2010 Honda Civic Wheel Bearing: Common Issues, Diagnosis and Replacement

The 2010 Honda Civic is a reliable and fuel-efficient car, but like any vehicle, it can experience issues over time. One common issue is a failing wheel bearing. A worn-out wheel bearing can cause a variety of problems, including:

Noise, such as a grinding or humming sound

Vibration in the steering wheel or seat

Difficulty steering

Uneven tire wear

Symptoms of a Bad 2010 Honda Civic Wheel Bearing

Symptom	Possible Cause
Grinding or humming noise when driving	Worn-out wheel bearing
Vibration in the steering wheel or seat	Worn-out wheel bearing
Difficulty steering	Worn-out wheel bearing
Uneven tire wear	Worn-out wheel bearing

Causes of a Bad 2010 Honda Civic Wheel Bearing

Cause	Solution
Normal wear and tear	Replace the wheel bearing
Impact damage	Replace the wheel bearing
Water damage	Replace the wheel bearing
Lack of lubrication	Grease the wheel bearing

How to Replace a 2010 Honda Civic Wheel Bearing

Replacing a 2010 Honda Civic wheel bearing is a relatively simple process that can be completed in a few hours. However, it is important to note that this is a safety-critical repair, and it should only be performed by a qualified mechanic.

Here are the steps involved in replacing a 2010 Honda Civic wheel bearing:

Safety first. Park the car on a level surface and engage the parking brake. Chock the wheels that will not be worked on.

Remove the wheel. Using a lug wrench, loosen the lug nuts on the wheel that is attached to the bad wheel bearing. Once the lug nuts are loose, remove the wheel.

Remove the brake caliper. The brake caliper is held in place by two bolts. Remove the bolts and then remove the brake caliper.

Remove the rotor. The rotor is held in place by a single bolt. Remove the bolt and then remove the rotor.

Remove the wheel bearing. The wheel bearing is held in place by a snap ring. Use a snap ring pliers to remove the snap ring and then remove the wheel bearing.

Install the new wheel bearing. Apply a thin layer of grease to the new wheel bearing and then insert it into the hub. Secure the wheel bearing with a new snap ring.

Install the rotor. Place the rotor on the hub and secure it with a new bolt.

Install the brake caliper. Place the brake caliper on the rotor and secure it with the two bolts.

Install the wheel. Place the wheel on the hub and tighten the lug nuts.

Success Stories

"I was having a lot of noise and vibration in my 2010 Honda Civic. I took it to my mechanic and he diagnosed the problem as a bad wheel bearing. He replaced the wheel bearing and now my car is running smoothly again." - John Smith

"I was driving down the highway when I heard a loud grinding noise. I pulled over and checked my tires, but they were all fine. I called my mechanic and he told me it was probably a bad wheel bearing. He was right, and he replaced it for me quickly and affordably." - Jane Doe

"I'm a do-it-yourselfer, and I replaced the wheel bearing on my 2010 Honda Civic myself. It was a relatively easy repair, and I saved a lot of money by doing it myself." - Joe Johnson

FAQs About 2010 Honda Civic Wheel Bearing

How long does it take to replace a 2010 Honda Civic wheel bearing? A qualified mechanic can replace a 2010 Honda Civic wheel bearing in about 2 hours.

How much does it cost to replace a 2010 Honda Civic wheel bearing? The cost to replace a 2010 Honda Civic wheel bearing varies depending on the labor rate of the mechanic and the cost of parts. However, you can expect to pay between $200 and $400 for the repair.

Can I replace a 2010 Honda Civic wheel bearing myself? Replacing a 2010 Honda Civic wheel bearing is a relatively simple repair, but it is important to note that this is a safety-critical repair, and it should only be performed by a qualified mechanic.

2010 Honda Civic Wheel Bearing: Common Issues, Diagnosis and Replacement